Mastertac Technical Information

ENG 3440
Date08.05.2019 SI
Sales Code97-H
TypeExtra permanent adhesive.
CompositionAcrylic, water borne.
UseSpecially designed for filmic face materials in Sheets format. For demanding substrates like HDPE drums and other rough surfaces.
Typical technical values
Typical technical values
Tack min12
Shear min2
Service temperature min-20
Service temperature max70
LimitationsHigh temperature/humidity during the storage might cause adhesive bleeding from the edges of the rolls. UV resistance of the adhesive is limited. Not recommended for transparent face materials.
DisclaimerThe performance of the product should always be tested in the actual application conditions. Our recommendations are based on our most current knowledge and experience. As our products are used in conditions beyond our control, we cannot assume any liability for damage caused through their use. Users of our products are solely responsible that the product is suitable for its intended application, and have determined such at their sole discretion. Users must comply with any applicable legislation and/or testing requirements for the finished article, and are responsible for bringing their products to market.

This publication does not constitute any warranty, express or implied, and is intended only for the recipient and cannot therefore be transferred to any third party. We cannot assume any liability for the use of our products in conjunction with other materials.

All our products are sold subject to UPM Raflatac’s general sales conditions, and you should ensure that any existing laws are observed.

This publication replaces all previous versions. All information is subject to change without notice.

   Download printable version:

   « Previous page